Fender Princeton Reverb Recording Amp

Model/Circuit Number:
Years of Production: 2007 – 2010
Era:
Configuration: Combo
Controls: Black forward facing w/ white labels
Knobs: Black skirted w/ chrome center, numbered 1 – 10
Faceplate

  • Front: In, In, Vol, Treb, Bass, Reverb, Pilot Light – Compressor: On/Off, Sensitivity, Level – Overdrive: On/Off, Overdrive, Tone, Level – Power Attenuator: Level
  • Rear: AC Outlet, Power Sw, Speaker Jack, Headphone Jack, Line Out, Line Level, FX Loop Send, FX Loop Receive, Footswitch

Cabinet

Tolex/Tweed:

Grill Cloth:

Logo: Grille mounted, raised, chrome & black script “Fender” w/ tail
Weight: 45 lbs. (Head)
Speaker:

    • Size: 1 x 10
  • Impendance: 8 ohm
  • Model:Jensen C10R

Effects: Reverb
Watts: 20 Watts
Tubes:

  • Pre amp: 12AX7
  • Power: 2 x 6V6
  • Bias: Fixed with bias adjustment pot.
  • Rectifier: Solid State
  • Phase Inverter: 12AX7 (Long Tailed)
  • Reverb Driver: 12AT7

Comments:

7 thoughts on “Fender Princeton Reverb Recording Amp

  • May 27, 2014 at 7:01 am
    Permalink

    I sure wish Fender would make schematics and service manuals available for there products-I think the speaker emulationon my Princeton is acting up, I think a cap is going-I dont see why they just cant publish everything its not like a secrret or something about how those things work-

    Reply
  • November 26, 2017 at 9:32 am
    Permalink

    Great amp for direct recording. The only negative is the big knob for attenuation is SUPER delicate. I had one that I bought from GC and it broke in the shipping. I ended up putting it up for consignment at a local store and it got broken there again. It’s an expensive job as the whole potentiameter needs to be replaced. My current one is in my studio and NEVER gets moved.

    Reply
  • December 9, 2017 at 7:41 pm
    Permalink

    I just repaired one of these amps- nothing major, just filter caps and toasted resistor. Sounds very good and I think the compressor on board is very good. I was able to get the schematic from Fender customer service with no issues and I’m not an authorized dealer or service center.

    Reply
    • January 6, 2019 at 5:54 pm
      Permalink

      Would you be kind to send me the schematics? I am in Brazil and Fender service here won’t give me? Also, if you have the foot switch schematics will be great because I lost mine. donatorodrigo@hotmail.com. Thanks and God Bless

      Reply
  • January 6, 2019 at 5:52 pm
    Permalink

    Would you be kind to send me the schematics? I am in Brazil and Fender service here won’t give me? Also, if you have the foot switch schematics will be great because I lost mine. donatorodrigo@hotmail.com

    Reply
  • April 17, 2022 at 4:35 pm
    Permalink

    where do you buy one of these

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *