Fender 300 PS
Model/Circuit Number: 300
Years of Production: 1975 – 1980
Era:
Configuration: Head
Controls: Black forward facing with white labels
Knobs: Black skirted with chrome center numbered 1-10
Schematics
Faceplate
- Front: In, In, Vol, Treb, Mid, Bass, Presence, Guitar/Bass Sw, 2300 Hz, 1250 Hz, 485 Hz, 235 Hz, 100 Hz, Distortion, Output – Pilot Lamp
- Rear:
Cabinet
- Dimensions: 22”w x 10 3/4”h x 13 1/4”d @ bottom (11 1/4”d @ top)
- Hardware: Casters
- Handle: 2 Black Strap Handles
- Feet: Sphinx glides (side mounted)
- Corners: Chrome Corners
Covering Material
- Tolex/Tweed: Black Tolex
- Grill Cloth: Black acoustic foam w/ white trim (early) or black grille cloth
Logo: Grill mounted, raised, Chrome and Black Script Fender without tail
Weight: 76 lbs
Speaker
- Size: 4 x 12
- Impedance: 8 ohms
- Model: Utah 012454(For more info, check out the Jensen Replacement Speakers)
Effects: Active EQ, Distortion
~Watts: 300 Watts
Tubes
- Pre amp: 2 x 7025, 12AX7, 6V6GTA, Transformer
- Power: 4 x 6550
Bias: Fixed
Rectifier: Solid State
Comments: Included a wheeled stand for the head. Later versions have an XLR Line out jack on the far left back panel in addition to the 1/4″ Line/Recording jack
i have one of these that i purchased from an old friend Jeff Dunn (son of Duck Dunn) it once belonged to his father.wondering about it’s value and where i may pick up some original or as close to original tubes.
I’m not sure about how to value the amp without having it in our possession, however, you can certainly pick up some new tubes from mojotone.com
i have one of these here in the uk have had it a few years its moved around with me through the years and yes its loud and also heavy to lump around and it still works did have some tubes replaced but not the originals they were close alternatives i would say the amp is worth as much as it is worth to you i was offered 1000 pounds in 1989 by the engineer who worked on it at the time but this was in the uk where they are rare
Hi, Could anyone tell me the measurements of the séaker enclosure of the 300PS Bass Amplifier ? Thanks Sergio
Use a JBL Wbin or one from the Altec series out of Voice of the theatre series .. you play everybodys pants off!
If anyone is looking to replace diodes A15N
Fender tell me they can be replaced with either 1N5407 or 1N5408 just thought some one might want to know