Fender Princeton Reverb Recording Amp
Model/Circuit Number:
Years of Production: 2007 – 2010
Era:
Configuration: Combo
Controls: Black forward facing w/ white labels
Knobs: Black skirted w/ chrome center, numbered 1 – 10
Faceplate
- Front: In, In, Vol, Treb, Bass, Reverb, Pilot Light – Compressor: On/Off, Sensitivity, Level – Overdrive: On/Off, Overdrive, Tone, Level – Power Attenuator: Level
- Rear: AC Outlet, Power Sw, Speaker Jack, Headphone Jack, Line Out, Line Level, FX Loop Send, FX Loop Receive, Footswitch
Cabinet
- Dimensions: 13 x 25 x 9-1/2
- Hardware:
- Handle: Black Strap
- Feet: Glides
- Corners: Corner Protectors
Tolex/Tweed:
Grill Cloth:
Logo: Grille mounted, raised, chrome & black script “Fender” w/ tail
Weight: 45 lbs. (Head)
Speaker:
-
- Size: 1 x 10
- Impendance: 8 ohm
- Model:Jensen C10R
Effects: Reverb
Watts: 20 Watts
Tubes:
- Pre amp: 12AX7
- Power: 2 x 6V6
- Bias: Fixed with bias adjustment pot.
- Rectifier: Solid State
- Phase Inverter: 12AX7 (Long Tailed)
- Reverb Driver: 12AT7
Comments:
I sure wish Fender would make schematics and service manuals available for there products-I think the speaker emulationon my Princeton is acting up, I think a cap is going-I dont see why they just cant publish everything its not like a secrret or something about how those things work-
Great amp for direct recording. The only negative is the big knob for attenuation is SUPER delicate. I had one that I bought from GC and it broke in the shipping. I ended up putting it up for consignment at a local store and it got broken there again. It’s an expensive job as the whole potentiameter needs to be replaced. My current one is in my studio and NEVER gets moved.
I just repaired one of these amps- nothing major, just filter caps and toasted resistor. Sounds very good and I think the compressor on board is very good. I was able to get the schematic from Fender customer service with no issues and I’m not an authorized dealer or service center.
Hi, I’ve been searching for the schematic, could you send it to me please, this is my email afroamerican27@hotmail.com, thanks
Would you be kind to send me the schematics? I am in Brazil and Fender service here won’t give me? Also, if you have the foot switch schematics will be great because I lost mine. donatorodrigo@hotmail.com. Thanks and God Bless
Would you be kind to send me the schematics? I am in Brazil and Fender service here won’t give me? Also, if you have the foot switch schematics will be great because I lost mine. donatorodrigo@hotmail.com
where do you buy one of these