Fender Super Champ X2

Model/Circuit Number: Fender Super Champ X2
Years of Production: 2012 – present
Era: Vintage Modified
Configuration: Piggyback head or Combo
Controls: Black forward facing w/ white screened labels
Knobs: Black skirted w/ chrome center, numbered 1 – 10
Faceplate

  • Front: Input, Volume 1, Channel Select, Gain, Volume 2, Voice (1-16), Treble, Bass, F/X Adjust, F/X Select, Tap Tempo, red jewel pilot
  • Rear: Power cable port, Power switch, 3A fuse, Speaker disconnect jack, Line Out jack, Footswitch jack, USB port

Cabinet

  • Dimensions: Head: 8″ H X 17.5″ W X 8.5″ D; Combo: 15″ H X 17.5″ W X 9.2″ D; SC112: 17″ H X 17.5″ W X 9.15″ D
  • Handle: Vinyl strap w/ nickel plated caps
  • Feet: Round black rubber

Covering Material

  • Tolex/Tweed: Black Tolex
  • Grill Cloth: Black white silver grill cloth

Logo: Grille mounted, raised, chrome & black script “Fender” w/ tail (Combo & SC112 only)
Weight: Head: 18.5 lbs Combo: 24 lbs SC112: 28 lbs
Speakers/Load: Combo: 1 X 10″ SC112: 1 X 12″

  • Speaker Model: Combo: Fender Special Design 10″ ceramic SC112: Celestion G12P-80
  • Effects: Vibratone, Delay, Reverb (w/ delay), Chorus (w/ delay & reverb), Tremolo
    Watts: 15 Watts
    Tubes

    • Pre amp: 1 X 12AX7
    • Power: 2 X 6V6GT

    Bias: Fixed
    Rectifier: Solid State

    Comments:
    USB accessible for programming and recording via Fender FUSE™ editor/librarian software.

    9 thoughts on “Fender Super Champ X2

    • May 3, 2015 at 11:08 am
      Permalink

      Also available, initially, as a factory special run with rough blonde Tolex and oxblood grill cloth. Black or blonde, IMHO the most bang for the buck in any amp Fender has ever made.

      Reply
    • September 18, 2016 at 10:40 pm
      Permalink

      One correction to this listing–the bias is not fixed, it IS adjustable.

      Reply
      • July 29, 2020 at 4:03 pm
        Permalink

        “Fixed” bias is a type of circuit for biasing. You can change the value of the resistor that controls the amount of bias: the circuit is still fixed bias. You can adjust the potentiometer that controls the amount of bias: the circuit is still fixed bias.

        Reply
    • December 29, 2016 at 7:45 am
      Permalink

      The 12AX7 is not a preamp tube, no matter what Fender says in their literature. The preamp is 100% solid state for both channels. The 12AX7 functions as a driver and phase inverter to drive the power tubes.

      Reply
    • January 9, 2018 at 9:50 pm
      Permalink

      Is there a way to add an effects loop to this amp. Seems to be the only thing missing on it

      Reply
      • July 29, 2020 at 4:05 pm
        Permalink

        It’s been done If you search the Web you’ll find instructions. It’s tricky to do, given the printed circuit board construction of the amp.

        Reply
    • September 27, 2018 at 1:16 am
      Permalink

      Is the X2 essentially the same circuit as the earlier XD model? I know the X2 has a USB port, which the XD does not have. But, other than that, are they the same?

      Reply
      • July 29, 2020 at 3:59 pm
        Permalink

        They are identical other than the USB interface. The default XD voice settings are different from the default X2 voice settings, but you can make them identical with Fender’s Fuse software.

        Reply

    Leave a Reply to Michael Watson Cancel reply

    Your email address will not be published. Required fields are marked *