Fender ’64 Vibroverb Custom

Model/Circuit Number: Fender ’64 Vibroverb Custom
Years of Production: 2003 – 2008
Era: Vintage Reissue
Configuration: Combo
Controls: Black forward facing w/ white screened labels
Knobs: Black skirted w/ chrome center, numbered 1 – 10

  • Front: “Normal” In 1 & 2, Bright switch, Volume, Treble, Bass, “Vibrato” In 1 & 2, Bright switch, Volume, Treble, Bass, Reverb, Speed, Intensity, red jewel pilot
  • Rear: Diode/Tube Rectifier switch, 3A fuse, Power cable port, Power switch, Standby switch, Int speaker jack, Ext speaker jack, Footswitch jack, Channel & Effect Kill switch, Reverb output, Reverb input


  • Dimensions: 19″ H X 25″ W X 10.5″ D
  • Handle: Vinyl strap w/ nickel plated caps
  • Feet: Glides
  • Hardware: Chrome tilt-back legs
  • Corners: Bottom, nickel plated

Covering Material

  • Tolex/Tweed: Black Tolex
  • Grill Cloth: Black white silver grill cloth

Logo: Grille mounted, raised, chrome & black script “Fender” w/ tail
Weight: 57 lbs.
Speakers/Load: 1 x 15″ / 4 ohms

  • Speaker Model: Fender Special Design by Eminence 15″ ceramic
  • Effects: Reverb, Tremolo
    Watts: 50 Watts

    • Pre amp: 4 X 12AX7, 2 X 12AT7
    • Power: 2 X 6L6GE

    Bias: Fixed
    Rectifier: 1 X 5U4GB / Solid State diodes


    3 thoughts on “Fender ’64 Vibroverb Custom

    • April 20, 2015 at 8:58 pm

      I believe the correct load on this amp is 8 ohms.

    • October 4, 2015 at 4:44 am

      Do you have this amp for sale?

    • June 1, 2016 at 6:14 am

      This incarnation of the Vibroverb was made for only a few months, and it is thought that fewer than 600 of these units were made.


    Leave a Reply to Chupacabras Cancel reply

    Your email address will not be published.